You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 67 Next »

Step 2: Mesh Geometry in GAMBIT

Mesh Edges

Before we mesh the faces, we should mesh the edges so that we can better define the mesh.

Following figure shows the edges with different mesh properties.

Higher Resolution ImageVisit page in new window

Label

Edge Mesh Properties

A

Interval Count: 36, Double First Length: 0.5

B

Interval Count: 36, Double First Length: 0.2

C

Interval Count: 30, First Length: 0.1

D

Interval Count: 18

E

Interval Count: 90, First Length: 0.1

F

Interval Count: 36

G

Interval Count: 72

H

Interval Count: 30

I

Interval Count: 36, Double First Length: 0.05


Operation Toolpad > Mesh Command Button > Edge Command Button  > Mesh Edges

Mesh edge 'A' through 'I' according to the properties shown on the table.

After we have all the edge meshes, we can mesh the faces:

Operation Toolpad > Mesh Command Button > Face Command Button > Mesh Faces

Select the face one by one. You can use the defaults of Quad (i.e. quadrilaterals) and Map. Click Apply.

The meshed face should look as follows:

Higher Resolution ImageVisit page in new window

Go to Step 3: Specify Boundary Types in GAMBIT

See and rate the complete Learning Module

Go to all FLUENT Learning Modules

  • No labels