Sign-up for free online course on ANSYS simulations!Unable to render {include} The included page could not be found.
Authors: Rajesh Bhaskaran & Sebastien Lachance-Barrett, Cornell University
Bifurcating Artery
Created using ANSYS 14.5
Geometry
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler.
Geometry (Artery without plaques)
Geometry (Plaque configuration #1)
Geometry (Plaque configuration #2)
Geometry (Blood Clot)
Mesh
Some of the settings you can use to get a better mesh are shown in the figure below.
- The Relevance Center can be set to coarse, medium and fine. After you pick the Relevance Center, you can change the Relevance from -100 to 100, with 100 being the finest within the particular relevance center.
You can insert a sizing for faces and edges along with the mesh settings in the figure.
You can give a bias to edge sizing to cluster cells towards one end of edge. See this page for how to implement a bias to an edge.
Below is a mesh we obtained by playing with these settings. This mesh resolves the separated flow behind the plaque better than the default mesh. It can be further improved though! You could start by changing the "edge sizings" in the left branch.
Streamlines
The following videos show how to plot streamlines using the CFD Post post-processor included in ANSYS Workbench. First, we plot streamlines emanating from the the inlet.
The streamlines emanating from the inlet do not include those in the recirculating region or the "deadwater" region. To see the streamlines in the recirculating region, we:
- Create points along a line within the recirculating region
Plot streamlines emanating from these points
Wall Shear
The following video shows how to plot wall shear along the left wall of the bifurcating artery.
Pressure Gradient
The procedure to create a contour plot of the pressure gradient is shown in the video below.
Comments
Unable to render {include} The included page could not be found.
First time using our Piazza discussion board? Please click on the following link for instructions on how to enroll in our class:
Don't worry, it is quick and easy! After enrollment, you will be able to access the discussion pages for all SimCafe tutorials. Rest assured that you can post anonymously if you wish.