Go to start of banner

ANSYS - Plate With a Hole Optimization

Go to start of metadata

You are viewing an old version of this page. View the current version.

Version 25

Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.

Plate with a Hole: Optimization

Created in ANSYS 14.5

Problem Specification

Consider a square plate with a hole in its center. The plate is made out of "Cornellium", which has a Young's Modulus of 30E3 ksi and a Poisson's Ratio of 0.3 . The length and width of the plate are both 10 inches. The hole in the middle of the plate is subject to a uniform pressure of 18.5 ksi in the outward radial direction. Due to the symmetry of this problem only one quarter of the geometry is needed as shown below.

The radius of the hole is the design variable. Furthermore, the radius is constrained between a minimum value of 1.0 inch and a maximum value of 2.5 inches.

Using ANSYS, minimize the volume of the plate by optimizing its radius, while staying underneath a maximum Von Mises stress value of 32.5 ksi.

Go to all ANSYS Learning Modules

• No labels