You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 22 Next »

[Problem Specification]
[1. Create Geometry in GAMBIT]
[2. Mesh Geometry in GAMBIT]
[3. Specify Boundary Types in GAMBIT]
4. Set Up Problem in FLUENT
5. Solve
6. Analyze Results
7. Refine Mesh
Problem 1

Problem 1

Problem

Use FLUENT to resolve the developing flow in a pipe (same configuration as was done in the tutorial) for a pipe Reynolds number of 10,000 on the following meshes: 100x5, 100x20 with uniform spacing in the radial direction. Plot the skin friction cf as a function of axial location for each grid. Compare the exit value with the expected value for fully developed flow (e.g., see White pgs. 345-346). Recall that a key question for the integrity of the mesh is the non-dimensional value of the first nodal point:

Unknown macro: {latex}

\large
$$

Unknown macro: {y_1}

^+ =

Unknown macro: {u_*y over v}

= \sqrt

Unknown macro: {tau_w over rho}

Unknown macro: {y_1 over v}

$$

This should be either less than 4 (so that you resolve down into the viscous sublayer) or greater than 30 (where wall functions can accurately compensate for the poorly resolved viscous sublayer). Intermediate values can lead to greater errors. Calculate the value of y1+ for each mesh; use that to help explain (briefly) the trends in the agreement that you observe.

Hints

If you no longer have the 100x5 or 100x20 mesh, you can download them here: pipe100x5.msh, pipe100x20.msh

Back to [Problem Specification]

See and rate the complete Learning Module

Go to all FLUENT Learning Modules

  • No labels