You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 17 Next »

Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.

Problem Specification

Consider a square plate with a hole in its center. The plate is made out of "Cornellium", which has a Young's Modulus of 30E3 ksi and a Poisson's Ratio of 0.3 . The length and width of the plate are both 10 inches. The hole in the middle of the plate is subject to a uniform pressure of 18.5 ksi. Due to, the symmetry of this problem only one quarter of the geometry is needed as shown below.


The radius of the hole is the design variable. Furthermore, the radius is constrained between a minimum value of 1.0 inch and a maximum value of 2.5 inches.

Using ANSYS, minimize the volume of the plate by optimizing its radius, while staying underneath a maximum Von Mises stress value of 32.5 ksi.

Go to Step 1: Pre-Analysis

See and rate the complete Learning Module

Go to all ANSYS Learning Modules

  • No labels