Unable to render {include} The included page could not be found.
Author: Ranjith Tirunagari, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation
Step 3: Mesh
In this section the geometry will be meshed using inflation feature.
Launch Mesher
In order to begin the meshing process, go to the Workbench Project Page, then (Double Click) Mesh.
Inflation Feature (Mesh Control).
Right-click on the Mesh, in the Outline view, choose Insert and then choose Inflation.
Mesh> Insert> Inflation
The Outline view should look something similar to the figure below.
Go to Step 4 - Setup (Physics)
Go to all FLUENT Learning Modules