You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Next »

Unable to render {include} The included page could not be found.

Author: John Singleton, Cornell University

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises

1. Pre-Analysis and Start-Up

Open ANSYS Workbench

Find where the ANSYS shortcut is located and launch ANSYS Workbench, as shown below.



Steady-State Thermal Analysis System

The problem at hand is a steady state thermal problem, thus the steady-state thermal analysis system will be used. Click on Steady-State Thermal(ANSYS) as shown in the image below.



Continue to hold down the left mouse button and drag Steady-State Thermal(ANSYS into the Project Schematic area. You will then see a green rectangle appear as shown below.



Drag Steady-State Thermal(ANSYS) to the green box which will then turn red and contain text saying "Create standalone system".



Now, release the left mouse button to create the standalone system. Your Project Schematic window should look comparable to the image below.



Lastly, rename the system to "2D Steady Conduction", as shown below.



Engineering Data

In this section the material properties of Cornellium will be inputted into ANSYS. First (Double Click) Engineering Data. Then click in the cell that contains the text "Click here to add a new material" and type in Cornellium as shown below.


Click Here for Higher ResolutionVisit page in new window


Next, (Expand) Thermal and (Double Click) Isotropic Thermal Conductivity, as shown below.

  • No labels