You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation

Problem Specification

The crank below (Figure 1.1) is fitted with a strain gauge and loaded as shown in Figure 1.2. The material is aluminum 6061-t6, the Young's modulus is 10,000 ksi, and the Poisson's Ratio is .33. Using hand calculations and ANSYS Workbench, determine the strain measured by the strain gauge.

Go to Step 1: Pre-Analysis & Start-Up

  • No labels