Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Include Page
ANSYS WB - Bike Crank - Panel
ANSYS WB - Bike Crank - Panel
Include Page
ANSYS Google Analytics
ANSYS Google Analytics

Problem Specification

A bicycle crank

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation

...

Problem Specification

The crank below (Figure 1.1) is fitted with a strain gauge and loaded as shown in Figure 1.2. The a 100 lb force is applied. The bicycle crank's material is aluminum 6061-t6, the Young's modulus is 10,000 ksi, and the Poisson's Ratio is .33. The dimensions (in inches) of the bike crank are shown below.

Image Added
Click here to enlarge the image

The bicycle crank is loaded such that the fitting on the right is fixed while the fitting on the left is loaded with a 100 lb force.
Image Added
Using hand calculations and ANSYS Workbench, determine the strain measured by the strain gaugea 5.64 mm strain gauge centered at (3.3748, -0.09409, .375) away from the force and aligned in the y-direction.

Go to Step 1: Pre-Analysis & Start-Up
Go to all ANSYS Learning Modules
See and rate the complete Learning Module