Page History

{alias:forced convection}

{include: FLUENT - Forced Convection - Panel}

h2. Problem Specification

!Forced Convection Problem Specification.png!

This tutorial shows you how to simulate forced convection in a pipe using ANSYS FLUENT 12. The simulation corresponds to the forced convection experiment in MAE 4272 at Cornell University. The diagram shows a pipe with a heated section in the middle where constant heat flux is added at the wall. The ambient air is flowing into the pipe from the left with a uniform velocity. What will be the steady state temperature at the outlet of the pipe? How will the temperature change along the pipe? We will tackle these questions in our simulation.We'll use FLUENT to solve the relevant boundary-value problem and obtain the velocity, temperature, pressure and density distribution in the pipe. Inputs necessary for the simulation, such as the velocity at the pipe inlet and heat flux added at the wall, are obtained from one particular experimental run. Results from the simulation will be compared with corresponding experimental values.


h4. Available Information

*Pipe Geometry:*
Circular cross-section
Pipe radius = 2.94e-2 m
Pipe length = 6.096 m

*Material Properties:*
Coeff. of viscosity = 1.787e-5 kg/(m s)
Cp = 1005 J/(kg K)
Thermal conductivity = 0.0266 W/(m K)
Molecular weight = 28.97 g/mole

*Inlet:*
• u = 25.05 m/s
• v = 0 m/s
• T = 298.15 K
• k = 0.09 m2/s2; epsilon = 16 m2/s3 (These are not measured and are rough guess values)

*Outlet:*
• Pressure = 97225.9 Pa


*Wall:*
• Heating between x = 1.83 m and x = 4.27 m
• Wall heat flux = 3473.9 W/m2
• Wall roughness: 0 (assume smooth)
• Wall thickness: 0 (assume negligible)

*Ambient conditions:*
• Ambient pressure = 98338.2 Pa


*[*Go to Step 1: Pre-Analysis & Start-Up*|FLUENT - Forced Convection - Step 1]*

[See and rate the complete Learning Module|FLUENT - Forced Convection]

[Go to all FLUENT Learning Modules|FLUENT Learning Modules]