AutoCAD Lamina Program

General Program Information

Input Definitions

Inputs Needed to Call the Channel Function

Inputs Defined within the Channel Function

origin - is a 3*1 matrix with x,y,z positions corresponding to the point where the first lamella will be drawn.

amp - specifies the amplitude of the lamina

w - specifies the width of an individual lamina

l - specifies the length of an individual lamina

t - specifies the thickness of an individual lamina

periods - specifies the period of one curve of the lamina.

angle - specifies the angle of the lamina relative to the floor of the tank.

num_baffles - specifies the number baffles in the tank

num_bafflescol -

xspace -

yspace -

Technical Program Outline

lamina₀ - The zoom_winA function creates a close-up view based on two points to specify the window size.

p1:

• x: origin₀ - w - zc
• y: origin₁
• z: origin₂

p2:

• x: origin₀ + w + zc
• y: origin₁ + 1 + zc
• z: origin₂

for loop - a for loop is created for the range from i = 0 to i = (periods*4).

lamina_last - Every time the program runs through the for loop another sine wave is drawn.

lamina{~}last:

• x: origin₀ + sin(πi/2)*amp
• y: origin₁ + i*(x/(periods*4)
• z: origin₂

lamina_i+1 - Uses the 'point' function to turn the 3*1 matrix lamina_last into a text format that AutoCad can read.

lamina_i+2 - Uses the 'concat' function to enter a space and the point (origin - zc_point)into AutoCad.

lamina_i+3 - Uses the 'point' function to turn the 3*1 matrix (lamina_last + zc_point) into a text format that AutoCad can read.

lamina_i+4 - Enters the command "offset" into AutoCad. The offset function is used to move the selected object a specified distance from its original location.

lamina_i+5 - Enters the variable "t" into AutoCad. t represents the distance that the selected object is to be offset. The command 'stringit' turns the the variable "t" into a dimensionless number.

lamina_i+6 - Uses the 'point' function to turn the 3*1 matrix 'origin' into a text format that AutoCad can read.

lamina_i+7 - Uses the 'point' function to turn the following 3*1 matrix into a text format that AutoCad can read.

• x: origin₀ + t
• y: origin₁
• z: origin₂

line₀ - Uses the 'concat' function to enter the point 'origin' a space and the point converted in line lamina_i+7 into AutoCad.

line₁ - Uses the 'concat' function to enter the point 'lamina_last' a space and the point described below into Autocad.

• x: lamina_last0 + t
• y: lamina_last1
• z: lamina_last2

lamina_i+8 -

lamina_i+9 -

lamina_i+10 -

lamina_i+11 -

lamina_i+12 -

lamina_i+13 -

lamina_i+14 -

lamina_i+15 -

lamina_i+16 -

lamina -