You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 35 Current »

This page has been moved to https://courses.ansys.com/index.php/courses/wind-blade-analysis-for-wind-power-using-ansys-fluent/lessons/numerical-results-lesson-7-22/
Click on the link above if you are not automatically redirected in 10 seconds.
   



Numerical Results

Depending on the mesh used, values for the torque on the blade can range from 0.02 to 0.04 N-m for the simulation as it was shown in the videos. Newer versions of ANSYS may use a different cell count, mesh quality, and solver algorithm which accounts for this discrepancy. 

In CFD-Post, when calculating the torque, newer versions of ANSYS do not let you select "Air" as the fluid. The two options under the "Fluid" dropdown are "All Fluids" and "Mixed" - the recommended selection is "All Fluids", but both selections should give you the same final answer for the torque.  




Go to Step 7: Verification & Validation

Go to all FLUENT Learning Modules

  • No labels