You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 74 Next »

Physics Setup

Material Assignment

At this point, we will tell ANSYS to assign the Aluminum material properties that we specified earlier to the geometry. First, (expand) Geometry then (click) Line Body, as shown below.



Then, (expand) Material in the "Details of Line Body" table and set Assignment to Aluminum, as shown below.


Click Here for Higher ResolutionVisit page in new window


At this point your "Details of Line Body" table, should look comparable to the following image.



Fixed Support

First, (right click) Modal > Insert > Fixed Support, as shown below.



Next, click the vertex selection filter button, . Then, click on the left end of the beam and apply it as the Geometry in the "Details of Fixed Support" table.

Constrain Beam to XY Plane

In this section the beam's motion will be constricted to the xy plane.

First, (right click) Modal > Insert > Displacement, as shown below.


Click Here for Higher ResolutionVisit page in new window


Next, click the edge selection filter button, . Then, click on the geometry and apply it as the Geometry in the "Details of Displacement" table. Lastly, set Z Component to 0, as shown below.



Save


Go to Step 5: Numerical Solution

Go to all ANSYS Learning Modules

  • No labels