Trachea Analysis Problem Specification

This tutorial shows how to simulate deformation of a trachea under a pressure load. Dimensions and properties used in this tutorial are: 

• 7 cartilage rings, each 300 degrees, thickness 1.1mm, width 5 mm, E = 2 MPa, Poisson's ratio = .3
• Tissue thickness 1 mm, width 10 mm, E = 20 kPa,  Poisson's ratio = .3
• Trachea diameter of 20 mm

Steps to modify properties (to model tracheomalacia) and geometry (to model tracheotomy) are shown in the exercises.

Below is a summary of Ansys steps demonstrated in the videos:

Go to Step 1: Pre-Analysis & Start-Up

Go to all ANSYS Learning Modules