Author: Rajesh Bhaskaran, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Physics Setup
5. Numerical Solution
6. Numerical Results
7. Verification & Validation
Exercises
Comments
Geometry
This page goes through the geometry steps for the Supersonic Flow Over a Wedge in the SpaceClaim geometry engine included with ANSYS Workbench. For instructions on creating the geometry using DesignModeler, see this page.
In later steps, the geometry will be split into two domains. To do this in SpaceClaim, simply go to the Design tab and choose Split under the Intersect section of the menu bar. Select the domain, and then select the point at the leftmost point of the wedge (the angled side).