Creating the Geometry for the Bolted Nozzle Flange

Created using ANSYS 16.2

Learning Goals

In this tutorial, you will learn how to create the geometry used for the Bolted Nozzle Flange problem presented in Module 3 of the Cornell's Engineering Simulations MOOC on edx.org.

You can access the MOOC here: A Hands-on Introduction to Engineering Simulations

Problem Specification

Check Module 3 of the MOOC

Geometry Creation

The steps on how to create the geometry for the Bolted Nozzle Flange are shown in the following videos.

Specifying the Contact Regions

Go to Step 1: Pre-Analysis & Start-Up

Go to all (ANSYS or FLUENT) Learning Modules