Physics Setup

ADD MATCH CONTROL TO MESH? (see wind blade tutorial)
Import mesh as a wbpz file instead o msh? 

Mesh info > size to check number o elements

It's always a good practice to check the mesh. Mesh > check and verify that there are no errors

Display mesh color by ID

before digging into the rest, we need to creat the mesh interfaces for the problem. The geometry is composed of 5 zones:
outer inner and inside blade zones. FIGURE showing this. The mesh created is "non-conformal" (i.e. the nodes does not match across the interface), so we need to tell Fluent that the ajudascent cells across that interface share information.

In order to do that, go under boundary conditions. set xxxx to interface. Note that "mesh interfaces" appeared under the setup menu. Click on that.

...

General: leaver p-based

Units: set to rpm

Models:viscous k-eps turb. Realizable

materials leave default. check density of xxx and visc of...

Cell zone conditions:

name zones, centroid, angular velocity. do for top blade

make table with values for other blades

Boundary Conditions:

-farfield 1: velocity inlet....

-farfield 2: pressure outlet...

etc

Go to Step 5: Numerical Solution

Go to all (ANSYS or FLUENT) Learning Modules