Verification & Validation

1. Perform additional runs with timesteps of 0.02 and 1s. Comment on the stability of the scheme relating to the timestep by comparing the residuals. 
2. Compare the residuals and the vorticity figures for a mesh of 128x64 or another mesh of your choosing. Is there any noticeable differences between the results using different mesh sizes?  

Effect of Uniform Initial Condition

In our simulation, we patched the cells behind the cylinder to have a starting velocity of .2 m/s so that we would get the vortex shedding earlier. This also allowed us to better see the oscilliation of the lift coefficient as flow time increased. 

Effect of Timestep on Solution

In order to effectively capture the vortex shedding, a small enough timestep was needed. It was recommeded to have roughly 20 - 25 timesteps per cycle hence we used a timestep of .2. The resulting plot in the numerical results showing how the lift coefficient oscillated due to the vortex shedding is shown below. To compare the effect of the timestep size, we continue to plot the lift coefficient after the oscillations have been established with a timestep of .02 seconds. 

Timestep = .2 s

Timestep = .2 -> .02s

Strouhal Number Comparison

 Go to Exercises
Go to all FLUENT Learning Modules