You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 28 Next »

Unable to render {include} The included page could not be found.

Step 6: Results

Note that you'll need to complete the code in the following post-processing modules in the PostProcessMenuFiles folder before you can plot the stress and strain:

  • CalcStrainStress.m
  • CalcPrincipals.m
  • CalcEffectiveStress.m


Before we dive into this step with full gusto, note that the Post-Processing field under our trusty pal Current Settings is empty. This signifies that the program is yet to calculate stress and strain from the nodal displacements. To calculate the stress and strain components, click on Strain, Stress under Post-Process. Voila, the program reports Stress/Strain done in Current Settings.

Plot σxx

In the Plotting menu, select Stress (xx).

We get a homogeneous state of stress as expected.

To save a copy of the plot, click on Plot in the Export menu. Save the plot as sigma_xx.fig. To convert the plot to the jpeg format, open sigma_xx.fig in MATLAB: at the MATLAB prompt, type open('sigma_xx.fig'). A MATLAB quirk is that the colorbar is not automatically displayed in this window. (Without the colorbar, the reader cannot determine the stress levels corresponding to the various colors.) To add the colorbar to the plot, click on the Insert Colorbar button in the toolbar at the top (see snapshot below).

In the figure window, select File -> Save as. Under Save as type, select JPEG image and click Save. Open the jpeg image from your working folder to verify that it has been created properly.

Plot σ11

To plot the principal stress σ11, select Stress (11) i n the Plotting menu. You'll get an error saying "Reference to non-existent field 'principals'". This is because we have not yet calculated the principal stresses from the stress components. Go to the Post-Process menu and select Principals. You'll see the message Principals done. Try plotting Stress (11) now.

We again get a homogeneous state of stress as expected. From the colorbar, the stress value is around 75 MPa which matches the applies normal traction. Click on Plot in the Export menu and save the plot as sigma_11.fig.

Export Data

To save all the data in the workspace, select Workspace in the Export menu. Specify rect.mat as the filename and click OK.

To see the information available in the help page for the Plotting menu, click on Help for this menu and scan through it. Click OK.

Now that we have our post processing results, we can continue to Step 7, where we will verify your results.

Go to Step 7: Verification and Validation

Go to all MATLAB Learning Modules

  • No labels