Problem Specification
1. Pre-analysis
2. Geometry
3. Mesh
4. Setup (Physics)
[5. Solution]
6. Results
[7. Verification and Validation]
Exercises
Step 6: Results
cloak.toggle.type = none
Highlight each line of the above panel and insert the appropriate links to the other pages of your tutorial
Highlight the bold line at the bottom of the page that read "Go to Step...". Insert the appropriate link to the next page of your tutorial.
Enter any relevant text, images, and videos in the space under where it says "cloak" below
After running the simulation, we should get these results:
Total Deformation:
The total deformation is greatest at the top of the truss, and has a magnitude of 0.28 mm.
Equivalent Stress
The greatest stress occurs in the Flexure mounts, and has a magnitude of 30MPa.
Directional Deformation
The Directional deformation is shown to range from -.04mm to +.04mm.
Joint Probes
Each joint probe shows the magnitude and direction of the force at each probe. The results show that there's a range from 200 N to a whopping 1500N. Fortunately, the 1500N force is in the center, and the flexure mount forces have a value around 400N.
[Go to Step 7: Verification and Validation]
Go to all ANSYS Learning Modules