You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.

T-Beam: Geometry

For axisymmetric models, we use cylindrical polar coordinates (r, θ, z) with no variation in the θ direction. So we can just model a slice in the (r, z) plane as shown below.


In ANSYS, the radial direction is x (rather than r) and the axial direction is y (rather than z). Confusing! We recommend that in an axisymmetric analysis, you think of the directions in ANSYS as radial & axial rather than "x" and "y".

Note that for axisymmetric models in ANSYS, the y-axis is always the axis of symmetry. The corresponding 3D geometry can be generated by revolving the 2D section 360° about the y-axis (we'll do this later in the Numerical Results step).


Below is the 2D geometry we need to model:

We use symmetry to model only half the total length of the cylinder.


We will first create a sketch and then a "surface body" from the sketch. The "surface body" is nothing but an area that we can mesh and apply boundary conditions to. The video below shows the steps to be followed to create the sketch and surface body. 

Continue to Step 3 - Mesh
Go to all ANSYS Learning Modules

  • No labels