ANSYS - Crack Between Neo-Hookean Material and Rigid Body - Problem Specification

Unable to render {include} The included page could not be found.

Authors: Tianshu Liu, Chia-Hsun Hsieh

Problem Specification
1. Pre-analysis & Start-up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation
8. Exercise

Problem Statement

As shown in the picture below, half of the infinite plane is Neo-Hookean material and the other half is a rigid body. There is a traction free crack tip with length 2a on the interface. The region that will be modeled is a small circle around the crack tip, as shown in the same picture. Neo-Hookean material will exhibit linear elastic behavior when the strain is small and the linear elastic crack solution will be set as the boundary condition in this model.

Go to Step 1 - Pre-Analysis & Start-Up
Go to all ANSYS Learning Modules

Space shortcuts

Child pages

Problem Statement