You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 15 Next »

Zero Blade Deflection with Steady Wind

Wind turbine blades typically deflect during operation and this results in reduction in generated electrical power. We will use a steady wind field to examine the effect of blade deflection on generated electrical power.

Start-up

Double click on the Bladed icon to launch GH Bladed.

The red circles next to each calculation and simulation in the calculation window indicate none of the required input parameters are defined. The yellow circle indicates that only a part of the required inputs are defined for a given simulation. Green circle indicates all the inputs are fully defined and the simulation is ready to be carried out.

We will fist load a demo project and then adjust the desired parameters. The demo project should be in the Bladed directory. This demo project simulates a 2MW wind turbine.

File > Open Project > demo_a.prj

Wind

The demo project uses a pre-defined turbulence wind file. We will change the wind characteristic to steady. Click on to edit the wind characteristic. The default wind is set to 3D Turbulent Wind with a mean wind speed of 12 m/s. This turbulent wind is defined in the demo wind file. For our case, we will use a steady wind of 11 m/s. Change the option to No Variation and change the Wind speed to 11 m/s. Change the Flow inclination to 0 degrees. Click on Apply to save the changes.


click here for full view


click here for full view

Blade Modes

GH Bladed performs modal analysis based on the defined blade stiffness. The modes are used to predict blade deflection. Thus, we can eliminate the blade modes to simulate zero blade deflection. Double click on Modal Analysis.

Change the number of blade modes to 0. Click OK to close the Modal Analysis Parameters window.

Simulation

We will run Start simulation because it simulates the start up response of a wind turbine. Highlight Start, and click on Run Now.

A warning message will appear. This message appears because we have changed the blade modes. Click on Yes to update the modal analysis to proceed.

Save the simulation result in the Bladed result folder (bladed 4.1\results). Name it startup_no_blade_deflection. Close the Calculation Progress window when the run is completed.

Results

We would like to compare the electrical power output of the demo wind turbine with and without blade deflection. The result for the case with blade deflection (blade mode unchanged) is provided below. Download and extract the files into the bladed result folder (bladed 4.1\results).

download the result for deflected blade simulation here

Click on Data View, this is where plots are generated.

In the Graph Parameters window, click on Channel 1 to select data.

Select "startup_no_blade_deflection" under Run Name. Select Summary information in Data Group. Select Electrical power for Variables. The electrical power will be plotted against time. Click on OK to finish data selection.


click here for full view

Click on Channel 2 and select "demo_steady_wind_11" under Run Name. Select summary information and electrical power, as shown in the previous step.

Channel 1 displays the electrical power produced by the demo turbine without blade deflection. Channel 2 displays the electrical power produced by the demo turbine with blade deflection. Click on View Graph, and you should get something like this:


click here for full view

We can check if the blades in our setup deflect or not. Select Blade 1 Deflections in Data Group. Select Blade 1 x-deflection for Variables. Select Time for Independent Variables.


click here for full view

From the graph, we see our setup does not yield any blade deflection.

  • No labels