You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 25 Next »

Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.

Step 6: Results

Total Deformation

First, examine the total deformation by clicking on the Total Deformation button, . If you have used only two elements, you should see the output shown below.

Click Here for Higher ResolutionVisit page in new window



If you have chosen to use 10 elements for your mesh, you should see the following output for the total deformation.

Click Here for Higher ResolutionVisit page in new window



The beam deformation can be animated by clicking on the play button, , which is located underneath the beam deformation results.

Maximum Bending Stress

For this static structural problem, the maximum bending stress is of interest. In order to examine the maximum bending stress first expand the Beam Tool folder, , which is located under "Solution(A6)". Next, click on the Maximum Bending Stress button, . If you have used only two elements, you should obtain the following output.

Click Here for Higher ResolutionVisit page in new window



If you have used ten elements for your mesh, you should get the output below.

Click Here for Higher ResolutionVisit page in new window



Go to Step 7: Verification & Validation

See and rate the complete Learning Module

Go to all ANSYS Learning Modules

  • No labels