Sign-up for free online course on ANSYS simulations!Author: John Singleton, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises
4. Setup (Physics)
Material Assignment
At this point, we will tell ANSYS to assign the Aluminum material properties that we specified earlier to the geometry. First, (expand) Geometry then (click) Line Body, as shown below.
Then, (expand) Material in the "Details of Line Body" table and set Assignment to Aluminum, as shown below.
At this point your "Details of Line Body" table, should look comparable to the following image.
Fixed Support
First, (right click) Modal > Insert > Fixed Support, as shown below.
Save
Go to Step 5: Solution
See and rate the complete Learning Module
Go to all ANSYS Learning Modules