Author: John Singleton and Rajesh Bhaskaran, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises
2. Geometry
Modal (ANSYS) Project Selection
Left, click on Modal (ANSYS), , and drag it to the right of the "Cantilever" project. You should then see a red box to the right of the "Cantilever" project that says "Create standalone system" as shown below.
Now, release the left mouse button. Your Project Schematic should now look comparable to the image below.
Rename Modal (ANSYS)
Double click on Modal (ANSYS) and rename it to "Cantilever Modal".
Attach Geometry from Cantilever to Cantilever Modal
The geometry for the "Cantilever Beam Modal Analysis" tutorial is the same as the geometry for the "Cantilever Beam" tutorial. Instead of recreating the geometry, we will simple attach the geometry from the Static Structural Analysis System (Cantilever) to the Modal Analysis System. In order to attach the geometry, left click geometry in Cantilever and drag it to geometry in Cantilever Modal, as shown below.
Then release the left mouse button. You should now see that the geometries are shared as shown in the following image.
Go to Step 3: Mesh
See and rate the complete Learning Module
Go to all ANSYS Learning Modules