Author: John Singleton and Rajesh Bhaskaran
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises
Under Construction: Please go to Step 3 to download the geometry and mesh files.
2. Geometry
Fluid Flow(FLUENT) Project Selection
Drag Fluid Flow(FLUENT) into the Project Schematic window.
Analysis Type
(Right Click) Geometry > Properties
Set Analysis Type to 2D
Launch Design Modeler
(Double Click) Geometry
Create Two Concentric Circles and Dimension
Create two concentric circles, centered around the origin in the xy plane. Set the diameter of the inner circle to 1m and set the diameter of the outer circle to 64 m.
Surface Body Creation
Concept > Surfaces From Sketches.
Set the Base Object to Sketch 1 (located underneath XYPlane in the Tree). Click Generate
Create a Bisecting Line
Click on XYPlane in the tree and it should highlight blue. Then, click the new sketch button, . In the new sketch draw a line on the y axis that goes through both of the concentric circles. Make sure that it is coincident to the y axis!
,
Go to Step 3: Mesh
See and rate the complete Learning Module
Go to all FLUENT Learning Modules