You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 14 Next »


Unable to render {include} The included page could not be found.




4. Setup (Physics)

Composite Setup

ANSYS Workbench does not have a GUI for composites, thus other measures must be taken. In order to model the laminate plate two command snippets must be inserted within Workbench and a new coordinate system must be introduced

Command Snippet 1

In order to create the first command snippet (Expand) Geometry > (Right Click) Surface Body > Insert > Commands. Many commands are needed to specify the composite material properties of the laminate plate. These commands are listed below in between the two lines of asterisks. Copy and paste the commands below into the Commands snippet, that you just created. Notice, that the purpose of each command is displayed to the right.

**********************************************************************************

/prep7                        !Call the Preprocessor

et,matid,181                !Specify the element type, shell 181
keyopt,matid,3,2          !Use full integration
mpdel,all,matid             !Delete all previously assigned material properties
tbdel,all,matid              !Delete all previouly assigned tabular data

MP,EX,1,25E6              !Define Young's Modulus: X Direction
MP,EY,1,1E6                !Define Young's Moduls: Y Direction
MP,EZ,1,1E6                !Define Young's Modulus: Z Direction
MP,GXY,1,5E5              !Define Shear Modulus XY
MP,GYZ,1,2E5              !Define Shear Modulus YZ
MP,GXZ,1,5E5              !Define Shear Modulus XZ

MP,PRXY,1,0.25            !Define Major Poisson's ratio XY
MP,PRYZ,1,0.01            !Define Major Poisson's ratio YZ
MP,PRXZ,1,0.25            !Define Majoy Poisson's ration XZ

sect,1,shell                    !Specify the section type
secdata,.025,matid,0     !Define thickness & orientation for layer 1
secdata,.025,matid,90   !Define thickness & orientation for layer 2
secdata,.025,matid,90   !Define thickness & orientation for layer 3
secdata,.025,matid,0     !Define thickness & orientation for layer 4
secoffset,MID               !Define thickness location

************************************************************************************

Command Snippet 2

In order to create the second command snippet (Right Click) Static Structural > Insert > Commands. Next, copy and paste the commands listed below in between the lines of asterisks into the second Command Snippet.

*******************************************************************

fini            !Exit current Module
/prep7        !Call the preprocessor
etcon,off    !Disable ANSYS from changin any KEYOPTS
fini            !Exit the preprocessor
/solu         !Call the Solve Module

******************************************************************

Go to Step 5: Solution

See and rate the complete Learning Module

Go to all ANSYS Learning Modules

  • No labels