You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

Unable to render {include} The included page could not be found.

Optimization

Set-Up of the Preliminary Optimization

Begin this step, by double clicking on Optimization. At this point, ANSYS must be told that the objective function(volume) is to be minimized while staying below the 32.5 KSI Von Mises stress threshold. Under, the "Table of Schematic B4: Optimization" change the Objective of Surface Body Volume to Minimize. Next, change the Objective of Equivalent Stress Maximum to Values <= Target. Then, set the Target Value of Equivalent Stress Maximum equal to 32,500 PSI. Now, execute the optimization by clicking Update Optimization. The optimization should yield the results shown, below.


Go to Step 7: Verification & Validation

See and rate the complete Learning Module

Go to all ANSYS Learning Modules

  • No labels