Results

Now we will examine the simulation results from ANSYS.

Mesh

Before we dive in to the solution, let's take a look at the mesh used for the simulation. In the outline window, click Mesh to bring up the meshed geometry in the geometry window.

XXXXXXXXXXXXXXXXPICTUREXXXXXXXXXXXXXXXXXXXX

Look to the outline window under "Mesh". Notice that there are two types of meshing types on the geometry: a mapped face meshing and a face sizing meshing. The mapped face meshing restricts the type of element shapes that will be used in the mesh - in this case, quadrilaterals. The face sizing controls the size of the elements. The size of each element is limited to at most 0.1 square inches. Another thing to notice about the geometry is that the geometry in the simulation is actually only one half of the geometry from the problem statement. This is done using symmetry constraints which allows the simulation can find the same answer as for the full geometry while saving valuable computation time because it is using fewer elements!

Sigma-r

Now, in the outline window, click Sigma-r. This will bring up the stress distribution for the stress in the r-direction.

XXXXXXXXXXXXXXXXXPICTUREXXXXXXXXXXXXXXXXXXX

Looking at the distribution, we can see that the stress varies only as a function of r as expected. Also, we can see that there seems to be some sort of stress concentrations in the are where the moment was applied. In our analysis, we ignored these transient stresses, but it is important to know that ANSYS calculated them when we try to obtain the solution to the problem statement. In order to further examine the stresses in the r-direction, lets look at an area far from the transient stresses in order to minimize their effect on the computational solution. Click on Sigma-r without transience. This solution is the stress in the r-direction at the midpoint of the beam. This line is far enough from the moment that the transient stresses will not affect its local stresses.

XXXXXXXXXXXXXXXXXPICTUREXXXXXXXXXXXXXXXXXXX

Click the Max and Min Tags in the menu bar: they will show the maximum and minimum stresses and their locations. Now, we can see that the maximum r-stress is -.110 psi, and the minimum r-stress is -82.302 psi.

Sigma-theta

Now click Sigma-theta in the outline window. This will bring up the stress distribution for the stress in the theta direction.

XXXXXXXXXXXXXXXPICTUREXXXXXXXXXXXXXXXXXXXXX

As with Sigma-r, the stress is a function of r, only. Also, there is some transience near the moment. Again, we will look at an area of the geometry far from the moment to decrease the transience's influence on our solution. Click Sigma-theta without transience in the outline window to bring up the stress distribution at the middle of the bar.

XXXXXXXXXXXXXPICTUREXXXXXXXXXXXXXXXXXXXXXXX

If they are not on, make sure to click on the max and min tags once again to see the maximum and minimum stresses. The maximum theta-stress is 1697.63 psi and the minimum theta-stress is -1916.2 psi

Solution at r = 11.5 Inches

Now that we have a good idea about the stress distribution, we will look specifically at solving the problem in the problem specification. First, we will look at the stress in the r-direction at r = 11.5 inches. In the outline window, click Sigma-r at r =11.5.