Pre-Analysis and Statup

Pre-Calculations

Click here to view the Pre-Calculations pertaining to this geometry. Remember, it is very important to do some sort of pre-calculation before doing any sort of computational simulation; otherwise, you may get incorrect results from the simulation and you will have nothing to compare the results to.

Open ANSYS Workbench

Now that we have the pre-calculations, we are ready to do a simulation in ANSYS Workbench! Open ANSYS Workbench by going to Start > ANSYS > Workbench. This will open the start up screen seen as seen below

To begin, we need to tell ANSYS what kind of simulation we are doing. If you look to the left of the start up window, you will see the Toolbox Window. Take a look through the different selections. The plate with a hole is a static structural simulation. Load the static structural tool box by dragging and dropping it into the Project Schematic.

Name the Project "Plate with Hole". Now we need to specify what type of material we are working with. Double click Engineering Data and it will take you to the Engineering Data Menus.

If you look under the "Outline of Schematic A2: Engineering Data" Window, you will see that the default material is Structural Steel. The Problem Specification specifies the material is Aluminum. To change the material, first right click structural steel under the click "Outline of Schematic A2: Engineering Data" Window delete it. Now, look into the Outline Window and click General Materials. In the General Materials find "Aluminum Alloy" and click the yellow plus sign to add the material to the project. Now, click return to project in the Menu Bar.

Now that the Material has been specified, we are ready to make the geometry in ANSYS.

Continue to Step 2 - Geometry
Go to all ANSYS Learning Modules