Step 1: Pre-Analysis & Start-Up
Optimizing Monitor Real Estate
This tutorial is specially configured, so the user can have both the tutorial and ANSYS open at the same time as shown below. It will be beneficial to have both ANSYS and your internet browser displayed on your monitor. Your internet browser should consume approximately one third of the screen width while ANSYS should take the other two thirds.
Open ANSYS Workbench
Click on the Start button, then click on All Programs. Depending on where you are attempting to access ANSYS, it may be under ANSYS 12.0, ANSYS 12.1 or Class. Once you locate ANSYS click on the the workbench button,
Static Structural Analysis System
The problem at hand is a static structural problem, so click and hold down the mouse button on the Static Structural (ANSYS) button,
Drag the Static Structural (ANSYS) button into the green box until it turns red and has the text "Create standalone system" within it, then release the mouse button.
Change the name of the project to Cantilever and your workbench window should look similar to the image below.
The specific properties of the material Cornellian needs to be inputted into ANSYS. Start by right clicking on Engineering Data and then clicking on "Edit.." as seen below.
At this point a new window will open. Under "Outline of Schematic A2: Engineering Data" there will be a box with text inside that says "Click here to add a new material". Click on that box and type in "Cornellian" and then press enter.
Now, expand the "Linear Elastic" tab on the right and double click on "Isotropic Elasticity".
Now, the properties of "Cornellian need to be inputted in to the "Table of Properties Row 2: Isotropic Elasticity" window. Set the temperature to 25 degrees C., set Young's Modulus to 2.8x10^(10) and set Poisson's Ratio to 0.4 .
At this point the project can be returned to. Click on the Return to Project button,
It would be of best interest, to save the project at this point. Click on the "Save As.." button,, which is located on the top of the Workbench window. Save the project as "Cantilever". When you save in ANSYS a file and a folder will be created. For instance if you save as "Cantilever", a "cantilever.wbpj" file and a folder called "cantilever_files" will appear. In order to reopen the ANSYS files in the future you will need both the ".wbpj" file and the folder. If you do not have BOTH, you will not be able to access your project.