Sign-up for free online course on ANSYS simulations!Problem Specification
Step 1: Pre-Analysis & Start-Up
Step 2: Geometry
Step 3: Mesh
Step 4: Setup (Physics)
Step 5: Solution
Step 6: Results
Step 7: Verification and Validation
Step 7: Verification and Validation
As we mentioned way back in Step 1, it is important to compare the redAnTs output to your own calculations: if one is very different than the other, neither result can be trusted.
From Pre-Analysis
The rectangle is under uniaxial tension with a load of 75 MPa; therefore, we expect the stress in the x' direction throughout the entire rectangle to be 75 MPa.
From redAnTS
Looking back to your results from redAnTS, we find that the program also found that the principal stress throughout the entire rectangle was 75 MPa, which means we can have some trust in our results.
While for this simulation it may seem trivial to check that the redAnTS output matches our expections, for more complex problems it becomes absolutely critical to verify your results. As you gain more experience with FEA simulations, you will be able to tell if a complex simulation may not "seem" right. This intuition can save you a great deal of frustration dealing with incorrect results.
This brings us to the end of our first little tour of FEA in redAnTS. Hope you enjoyed the joyride. Goodbye!