Non-Linear Doser SU 2009

Methods

Sizing the Orifice

The orifice between the rapid mix and floculation tanks is designed to produce a difference in water level high that can then be sensed by a float which would then change the flow rate of aluminum sulfate :

where

• h _l the difference in head loss between the maximum CDC head loss and the actual head loss in the flexible dosing tube
• K _DoseOrifice is the required minor loss coefficient through the orifice
• V _DoseTube is the velocity in the dosing tube

This head was then used to determine the velocity of the water through the orifice and the residence time. Using the following equations:

V=

theta=

Once these values were determined, we were able to calculate the energy dissipation rate using the following equation.

We sought to keep the energy dissipation between .5 and 1 W/kg.

Lever Arm and Float

We first must determine the size of the counterweight on the doser arm in order to ensure that the dosage will only be a function of the difference in water height in the flocculation and rapid mix tanks. The mass of the weight is calculated by determining the mass of the doser when full.

]

where D.actual is the difference between the given diameter of the dosing tube and the measured diameter of the dosing tube

The size of the float can be determined using a moment balance around the pivot of the lever arm. This is to ensure that a change in head in the entrance tank will cause a similar change in the relative height of the float. The float was sized using the same float sizing algorithm used by the linear CDC. Based on this we found that a float of 13.3 inches would theoretically be able to measure a .25cm height difference.

h.3 Conclusion

Based on our calculations, we found that an orifice of 8cm would give us an acceptable energy dissipation rate of .927 W/kg and would require a 13.3in float. This float would have a .25cm sensitivity over a 20.3cm height difference.