Energy Dissipation Flocculation Design Program
This flocculator program determines the size of the flocculator channels and number and spacing of baffles based on a set energy dissipation rate determined for each 180 degree turn around a baffle.
Flocculator Program Inputs and Outputs
Flocculation Tank Program Inputs
Flocculation Tank Program Outputs
Flocculation Tank AutoCAD Drawing Program
Flocculation Design Algorithm
The first step in the flocculator program is to assume that the headloss of the water traveling from the end of the flocculator to the sedimentation tank is negligible, with this assumption it was determined that the height of the water at the end of the flocculator is the same and water height in the sedimentation tank. The largest baffle spacing was set to be one half of the height of water at the end of the flocculator.
The width of the flocculator channels are calaculated to give the final spacing of the flocculator section a set energy dissipation rate. The equation used can be seen below.
Unknown macro: {latex}
/large
$${W_{FlocChannel}} = {{2{Q_
Unknown macro: {Plant}
}} \over {H{W_{FlocEnd}}}}{\left( {{{{K_
Unknown macro: {FlocBaffle180}
}} \over {2P{i_{Epsilon}} \cdot H{W_{FlocEnd}} \cdot E{D_
Unknown macro: {FlocFinal}
}}}} \right)^{1/3}}$$
If this calulated width is smaller than 45 cm then the width of the flocculator channel will default to 45 cm. This minimum value was set to ensure that a person can fit into the channel for constuction purposes.
The Flocculator was divided into spacing sections. Each section was set to have a different and decreasing energy dissipation rate. The spacing for each section was determined by the following equation using the three different values of energy dissipation set in the design assumptions.
Unknown macro: {latex}
/large
$${S_{FlocBaffle}} = {{{Q_
Unknown macro: {Plant}
}} \over W_{FlocChannel}}{\left( {{{{K_
Unknown macro: {FlocBaffle180}
}} \over {2P{i_{Epsilon}} \cdot H{W_{FlocEnd}} \cdot E{D_
Unknown macro: {Floc}
}}}} \right)^{1/3}}$$