Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.
Bike Crank: Part 2
Created using ANSYS 14.5
Learning Goals
In this tutorial, you will learn to:
- (e.g.: Determine the displacements and stresses in a bike crank using 3D FEA capabilities in ANSYS Mechanical)
- (e.g.: Verify the finite-element results from ANSYS by refining the mesh and also comparing with hand calculations)
Under Construction
Problem Specification
Consider adding a strain rosette to the ANSYS bike crank model, from the previous bike crank tutorial, to predict the strain that would be measured by a rosette mounted on the crank model. The rosette is placed along the top edge on the front face of the crank, midway between the support hole and the loaded hole. The specifications of the rosettes are shown below.
Under Construction