FLUENT - Compressible Flow in a Nozzle- Step 5

Step 5: Solution

Now we will set the solve settings for this problem and then iterate through and actually solve it.

Solve > Control > Solution

We'll just use the defaults. Note that a second-order discretization scheme will be used. Click OK.

Set Initial Guess

Main Menu > Solve > Initialize > Initialize...

As you may recall from the previous tutorials, this is where we set the initial guess values for the iterative solution. We'll set these values to be the ones at the inlet. Select inlet under Compute From.

Click Init. The above values of pressure, velocity and temperature are now assigned to each cell in the grid. This completes the initialization. Close the window.

Set Convergence Criteria

FLUENT reports a residual for each governing equation being solved. The residual is a measure of how well the current solution satisfies the discrete form of each governing equation. We'll iterate the solution until the residual for each equation falls below 1e-6.

Main Menu > Solve > Monitors > Residual...

Change the residual under Convergence Criterion for continuity, x-velocity, y-velocity and energy to 1e-6.

Also, under Options, select Plot. This will plot the residuals in the graphics window as they are calculated.

Click OK.

Iterate Until Convergence

Main Menu > Solve > Iterate...

In the Iterate Window that comes up, change the Number of Iterations to 500. Click Iterate.

The residuals for each iteration is printed out as well as plotted in the graphics window as they are calculated.

Save case and data after you have obtained a converged solution.

Go to Step 6: Results

See and rate the complete Learning Module

Go to all FLUENT Learning Modules