Sign-up for free online course on ANSYS simulations!Author: John Singleton and Rajesh Bhaskaran, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises
2. Geometry
Attach Geometry from Cantilever to Cantilever Modal
The geometry for the "Cantilever Beam Modal Analysis" tutorial is the same as the geometry for the "Cantilever Beam" tutorial. Instead of recreating the geometry, we will simple attach the geometry from the Static Structural Analysis System (Cantilever) to the Modal Analysis System (Cantilever Modal). In order to attach the geometry, left click geometry in the "Cantilever" project and drag it to geometry in the "Cantilever Modal" project, as shown below.
Then release the left mouse button. You should now see that the geometries are shared as shown in the following image.
Go to Step 3: Mesh
See and rate the complete Learning Module
Go to all ANSYS Learning Modules