Design Team Meeting Minutes

Spring 2009 Minutes

April 10, 2009

Working Group: MathCAD

Accomplishments

• Sed. Inlet Slopes program adjusted so the measurement of the gap between the last plate & the wall is given.
  • This gap will essentially be a fraction of a slope plate.

Metrics

• The number of actual ports/slopes in the sed tank was being overestimated. Upon review, it was found that the calculation of the port number was based on L.SedMax, not L.Sed (the actual length of the tank).

Outcomes

• Length of the slopes need to be altered.
• Sludge drain width needs to be altered to make sure enough width is given underneath the slopes to prevent breaking.
  • Make sure it is at least 2.5cm.

Issues

• Other MathCAD issues from the task list are still being resolved.

Working Group: AutoCAD

Accomplishments

• Skeleton of the sed tank can now be drawn.

Metrics

Outcomes

• Based on feedback from Monroe & Honduras, the position of the inlet drop chimneys needs to be changed so walls are shared.
• A false bottom needs to be added in the AutoCAD rendering (15cm)
  • The slopes and the rest of the fill are then to be drawn as a single unit
• Lamella need to be drawn to incorporate the pvc frame

Issues

• Sed tank AutoCAD Algorithms need to be rewritten, rather than adjusted--just too complicated.

Any Overall Team Comments:

We have updated the Task List based on feedback from Honduras and Monroe.