Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Panel

Problem Specification
1. Pre-Analysis & Start-up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation




...

Note that for each mesh face, we only define 2 mesh edges. Gambit will automatically define the other two mesh edge for face mesh creation. Manual mesh of all edges can be done if more control of the mesh is required. Please refer to the index of the GAMBIT User Guide and look under Edge>Meshing for explanation on other type of meshing parameters.

Go to Step 3: Mesh

See and rate the complete Learning Module

Go to all FLUENT Learning Modules