Page History

...

In this section, we will go in the DesignModeler to draw the rosetteinto DesignModeler, the geometry engine, to sketch each gauge of the rosette on the front face of the crank. We will then create surface elements from our drawing. These will later be imported into mechanical in the meshing stepsurfaces for each gauge from the sketch. We first need to define a new coordinate system, as shown in the video below. 

...

This video will show you how to insert a midpoint, which will be helpful to put place the gauges at their correct locations. We will also show you how to copy your gauge to make the other two.

...