Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Include Page
SIMULATION: FLUENT Google Analytics
SIMULATION: FLUENT Google Analytics
Include Page
SIMULATION: 3D Convection through an Electronics Box - Panel
SIMULATION: 3D Convection through an Electronics Box - Panel
Panel

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation

Geometry

Download Geometry Files

Click here to download the geometry. Save the file somewhere convenient, such as your desktop.

Load the Geometry into ANSYS

In ANSYS, go to File > Import. This will allow us to import the geometry from outside ANSYS into our workspace. First, make sure the file extension box is set to Geometry File. Next, browse to geometry file, select it, and press OK. The geometry file should now appear in the Project Schematic window.

Open the Geometry

Next, open the geometry file by double clicking it in the Project Schematic window.

...

As you can probably tell, ANSYS does not generate the model automatically, so we need to generate the geometry. Click to generate the geometry.

Create a Flow Geometry

Caps

The next step is for us to create a flow geometry. The air is going to flow through the inside of the box; however, we need to create a geometry for this empty space in order for ANSYS to be able to calculate the solution. We will accomplish this by creating Caps, then using those caps to create Fill. In the menu bar, select Tools > Fill. In the Details window, name the fill Caps, and make sure the extraction type is set to By Cavity.

...

To select these surfaces, use the Face Selection Filter Hold down CTRL to select multiple surfaces at once. When all the surfaces have been selected, press Faces > Apply in the Details window. 40 surfaces should have been selected.

Fill

Next, we need to create the fill geometry. Once again, go to Tools > Fill. Name the fill, FlowGeometry. Also, we need to change the Extraction Type. Select Extraction Type > By Caps. The other parameters should be left as their defaults. Press to create the fill geometry.

Form New Part

In the Outline window, select all of the parts in the tree, right click, and select Form New Part

Connect Geometry to Project

Finally, we are ready to connect the geometry to the project. Close the design modeler, and return to the Project Schematic. Connect the geometry to the project by clicking and dragging the Geometry to Mesh

...

Once the geometry has been connected, save the project.

Go to Step 3 - : Mesh

Go to all FLUENT Learning Modules