...

...

Author: Ben Mullen, Cornell University

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation

Pre-Analysis and Start-Up

Open ANSYS Workbench

We are ready to do a simulation in ANSYS Workbench. Open ANSYS Workbench by going to Start > ANSYS > Workbench. This will open the start up screen seen as seen below

...

Name the Project Wind Turbine Blade by doubling clicking {Static Structural (ANSYS)}} underneath the project schematic.

Go to Step 2 - Geometry
See the complete Learning Module: Geometry

Go to all ANSYS Learning Modules