Cantilever Beam

Problem

...

Specification

Consider the beam in the figure below.  It is clamped on the left side and has a point force of 8kN acting downward on the right end of the beam. The beam has a length of 4 meters, width of 0.346 meters and height of 0.346 meters (cross-section is a square). Additionally, the beam is composed of a special material called Cornellium which has a Young's Modulus of 2.8x10^10 Pa. Using ANSYS, calculate the following:

1. Deformation of the beam
2. Maximum bending stress along the beam
3. Bending moment along the beam

Go to Step 1: Pre-Analysis & Start-UpSee and rate the complete Learning Module

Go to all ANSYS Learning Modules