Page History

...

Now, the properties of the fluid that is being modeled will be specified. The properties of the fluid were specified in the Problem Specification section. In order to create a new fluidfluid (Click) Problem Setup > Materials > Fluid > Create/Edit... as shown in the image below. Image Added

In the Create/Edit Materials menu set the Density to 1.331 kg/m^3 (constant) and set the Viscosity to 2.34e-05 kg/(ms) (constant) as shown in the image below.

Image Added
Higher Resolution Image

Click Change/Create. Close the window.

Define Boundary Conditions

At this point the boundary conditions for the three Named Selections will be specified.

...

Inlet Boundary Condition

...

In order to start the process (Click) Problem Setup > Boundary Conditions > inlet > Edit... as shown in the following image. Image Added
Higher resolution Image

Go to Step 5 - Solution
Go to all FLUENT Learning Modules