Page History

...

Here R = radius of the pipe, and L = length of the pipe. Rotating the above rectangle 360 degrees about the axis will recover the full pipe geometry.The radial direction is label as "y" in FLUENT.

Start ANSYS FLUENT

This tutorial is specially configured, so the user can have both the tutorial and ANSYS open at the same time as shown below. It will be beneficial to have both ANSYS and your internet browser displayed on your monitor. Your internet browser should consume approximately one third of the screen width while ANSYS should take the other two thirds. You can use the windows command Alt + Tab to switch screens.

We'll run FLUENT within the ANSYS Workbench interface.  Start ANSYS workbench:

...