Include Page |
---|
| SIMULATION: ANSYS 12 - Plate With a Hole Optimization - Panel |
---|
| SIMULATION: ANSYS 12 - Plate With a Hole Optimization - Panel |
---|
|
Include Page |
---|
| SIMULATION: ANSYS Google Analytics |
---|
| SIMULATION: ANSYS Google Analytics |
---|
|
Problem Specification
Consider a square plate with a hole in its center. The plate is made out of Cornellium, which has a Young's Modulus of 30x10^3 KSI and a Poisson's Ratio of 0.3 . The length and width of the plate are both 10 inches. The hole in the middle of the plate is subject to a uniform pressure of 18.5 KSI. Due to, the symmetry of this problem only one quarter of the geometry is needed as shown below.
The radius of the hole is the design variable. Furthermore, the radius is constrained between a minimum value of 1.0 inch and a maximum value of 2.5 inches.
...