...
The right side of the rectangle has a convective boundary condition with a Biot Number of 5 and and ambient temperature of 0. To implement this boundary condition, (Right Click) Steady-State Thermal > Insert > Convection , as shown below.
newwindow | ||||
---|---|---|---|---|
| ||||
https://confluence.cornell.edu/download/attachments/146918515/InsConv_Full.png |
Next, click on the right side of the rectangle and (Click) Apply in the "Details of Convection" table. Then, set the Film Coefficient to 5 and set the Ambient temperature to 0 degrees Celsius, as shown below.
newwindow | ||||
---|---|---|---|---|
| ||||
https://confluence.cornell.edu/download/attachments/146918515/DetConv_Full.png |
This, concludes the setup process.
Save
Save the project now. Do not close Mechanical.
Go to Step 5: Solution
See and rate the complete Learning Module
Go to all ANSYS Learning Modules