Page History

...

Now we can constraint the lower rectangle with the top of the rectangle. Click Constraints tab, select Equal Length. Click the appropriate top and bottom edge and set them to be of equal length. This is shown below:

Dimensions

...

Now we will specify the appropriate dimensions and constraints. Below is the summary of geometry of the pipe:

...

Under Sketching Toolboxes, select Dimensions tab, use the default dimensioning tools. Then click on the lines and drag upwards or sideways as the case may be to place the dimensions (V1, H2, H3, H4). Note: For horizontal dimensioning (shown in H2, H3 and H4), click first on the horizontal dimension tab under the dimensions tab and then click (turns yellow) on the end points of the split section lines (H2, H3 and H4). Then click on any point on the y-axis and drag up. For the vertical dimensioning (V1), click on the vertical dimension tab under the dimensions tab. Then click on the any point on the x-axis then click on V1 (turns yellow). Then drag V1 to the left side.

...