Page History

...

Since we have a heated section in the middle of the pipe, we need to split the geometry appropriately. Click Modify tab and select Split. Roughly select two points on the top and bottom of the rectangle where there will be a heated section.

Now we can constraint the lower rectangle with the top of the rectangle. Click Constraints tab, select Equal Length. Click the appropriate top and bottom edge and set them to be of equal length. This is shown below:

Dimensions and Constraints

...

Under Details View on the lower left corner, input the value for dimension appropriately. Then hit enter each time each dimension is entered.
V1: 0.0294 m
H2: 1.83 m
H3: 4.27 m
H4: 6.096 mNow we can constraint the lower rectangle with the top of the rectangle which has been properly dimensioned. Click Constraints tab, select Equal Length. Click the appropriate top and bottom edge and set them to be of equal length.

At this point, you should see something like this for your sketch:

...